You are here:Home » CMM probes » CMM support » Knowledgebase » PH10 and PHC10-3 system interconnection diagrams

PH10 and PHC10-3 system interconnection diagrams

This section describes a number of PH10 system interconnection and recommended interconnection cables

PH10 with two-wire TTPs

 

1Communication connection to CMM controller - RS232 or USB
2Raw probe signal to OEM interface

 

.

PH10 2 wire TTPs with autochange 
KeyDescription
 1 Communication connection to CMM controller RS232 or USB 
 3 Communication to CMM controller
 4 Communication to autochange rack
 5 PICS output to CMM controller
 6 Probe output to CMM controller
PH10 system with multiwire probe and autochange 
KeyDescription
 1 Communication connection to CMM controller - RS232 or USB
 3 Communication to CMM controller
 4 Communication to autochange rack
 5 PICS output to CMM controller
 6 Raw probe output to CMM contoller