Preferred standard accuracy probe for large VTL's
A touch-trigger probe with radio transmission for communicating with the machine's CNC controller, for component setting/inspection on machining centres.
The RMP60M is also available which enables probe inspection of part features that would be inaccessible to the standard RMP60. It allows fitment of adaptors, extensions and Renishaw's LP2 touch probe.
RLP40 pioneers the application of frequency hopping spread spectrum (FHSS) radio transmission in the turning centre environment
The RMP40M is also available which enables probe inspection of part features that would be inaccessible to the standard RMP40. It allows fitment of adaptors, extensions and Renishaw's LP2 touch probe.
The OLP40 can use Renishaw's legacy or modulated optical signal transmission systems without any compromise in metrology performance. When used with an OMI-2T interface unit, two OLP40s can be used on the same machining centre
Pocket guide to probes for CNC machine tools
An easy to use pocket guide introducing Renishaw's range of probing solutions for CNC machine tools. Process control solutions.
Technical specifications: Probing systems for CNC machine tools
The type of probing system that you need will depend on your machine tool and the nature of the probing application. This document focuses on the main applications for probing on machine tools. It contains an introduction to the use of probing for each application, plus guidance on the selection of the most appropriate system and technical information about each probe.