Skip navigation

Preferred standard accuracy probe for large VTL's

RMP60

RMP60

 A touch-trigger probe with radio transmission for communicating with the machine's CNC controller, for component setting/inspection on machining centres.

RMP60

Alternative

RMP60M

RMP60M

The RMP60M is also available which enables probe inspection of part features that would be inaccessible to the standard RMP60. It allows fitment of adaptors, extensions and Renishaw's LP2 touch probe.

RMP60M

RLP40

RLP40

RLP40 pioneers the application of frequency hopping spread spectrum (FHSS) radio transmission in the turning centre environment

RLP40

RMP40M

RMP40M with LP2

The RMP40M is also available which enables probe inspection of part features that would be inaccessible to the standard RMP40. It allows fitment of adaptors, extensions and Renishaw's LP2 touch probe.

RMP40M

OLP40

OLP40

The OLP40 can use Renishaw's legacy or modulated optical signal transmission systems without any compromise in metrology performance. When used with an OMI-2T interface unit, two OLP40s can be used on the same machining centre 

OLP40

 

Downloads

  • Brochure: Pocket guide to probes for CNC machine tools Brochure: Pocket guide to probes for CNC machine tools

    An easy to use pocket guide introducing Renishaw's range of probing solutions for CNC machine tools. Process control solutions.

  • Technical specifications: Probing systems for CNC machine tools Technical specifications: Probing systems for CNC machine tools

    The type of probing system that you need will depend on your machine tool and the nature of the probing application. This document focuses on the main applications for probing on machine tools. It contains an introduction to the use of probing for each application, plus guidance on the selection of the most appropriate system and technical information about each probe.