RMP60 (1st generation)

A touch-trigger probe with radio transmission for communicating with the machine's CNC controller, for component setting/inspection on machining centres.

RMP60 uses a unique frequency hopping spread spectrum (FHSS) radio transmission system that makes it ideal for use on large and 5-axis machines.

Page contentDownloads

About RMP60 (1st generation)

RMP60 is part of radio transmission part probing systems, ideally suited to large machining centres or where line-of-sight between probe and receiver is difficult to achieve.

RMP60 features an integrated probe module delivering exceptional robustness and generous overtravel.

RMP60 complies with FCC regulations and operates in the 2.4 GHz band. It delivers interference-free transmission through the use of FHSS (frequency hopping spread spectrum). This allows many systems to operate in the same machine shop without risk of cross-talk.

The RMI integrated interface/receiver is used to communicate between the RMP60 probe and the machine control.

The probe may be activated by RF signal initiated by an M-code, spinning or shank switch.

RMP60 (1st generation) has been superceded, and is no longer available from Renishaw.

Quick-start guide

Installation guide