Skip navigation

Optical encoders compliance certificates

Select the required compliance data from the list and table below:
ProductsCE
Advanced Diagnostic ToolEU2018-029
ATOM™ diagnostic equipmentECD2016-23
ATOM cabled readheadsECD2016-21
ATOM FPC readheadsECD2016-22
ATOM DX™ readheadsEUD2019-60
B2B ACiEU2017-167
EVOLUTE™ readheadsECD2016-27
RESOLUTE™ and DRIVE-CLiQECD2016-26
RESOLUTE™ Functional Safety and DRIVE-CLiQEU2018-094
QUANTiC™EU2018-005
RGH20ECD2016-28
RGH22ECD2016-29
RGH24ECD2016-30
RGH25ECD2016-31
RGH34ECD2016-34
RGH40ECD2016-35
RGH41ECD2016-36
RGH45ECD2016-37
Ri interfaceECD2016-25
Ti interfaceECD2016-24
TONiC™ readheads, interfaces, accessoriesECD2016-41
SiGNUM™ readheads, interfaces, accessoriesECD2016-44
VIONiC™ readheadsECD2016-42

EU declarations of conformity

CE marking requires that an EU declaration of conformity is prepared for each product. Please find the declarations for each encoder system in this table. (Please note that scale products do not fall within the scope of CE marking so no declarations are available.) 

RoHS

The new RoHS Directive 2011/65/EU requires that all encoder systems are compliant by 22nd July 2017. All encoder systems are RoHS compliant as shown by the CE certificates in this table. If you need an RoHS certificate for a specific product variant then please contact EPD.Compliance@Renishaw.com.

WEEE

Guidance regarding end of life disposal is included in product installation guides.

Material safety data sheet

Please refer to the RGG-2 2 part adhesive material safety data sheets.

Functional safety for SiGNUM series (legacy product)

The SiGNUM analogue encoder system has been certified by DGUV against ISO13849-1:2008 as being suitable for use in applications requiring up to performance level d (PLd). 

For information about the functional safety performance of other encoder systems, please contact EPD.Compliance@renishaw.com.

Conflict Minerals, REACH, Green Procurement Standard and other regulations or standards

Please contact EPD.Compliance@renishaw.com.

Functional safety for RESOLUTE Siemens DRIVE-CLiQ

The RESOLUTE FS Siemens DRIVE-CliQ Encoder System has been certified by CSA Sira, reference certificate number FSP16008/00, against ISO 13849:2015 as being suitable for use in applications requiring up to performance level d (PLd) and against IEC 61508:2010 / IEC 61800-5-2:2007. For information about the functional safety performance of other encoder systems, please contact EPD.Compliance@Renishaw.com.

ISO 9001

Renishaw's quality assurance system and procedures are audited for compliance with ISO 9001, the internationally recognised standard for quality management systems. Renishaw's certificate of registration to EN ISO 9001 is issued by BSI Management Systems and carries the UKAS accreditation logo. This is your assurance that not only does Renishaw operate procedures to the ISO standard, but the company has been audited and certified by a competent, UKAS accredited, organisation. UKAS accreditation is recognised in many countries worldwide by their relevant national body. If you need more information, please contact EPD.Compliance@Renishaw.com.