Navigation
PHS1 troubleshooting
NOTE: Due to the extent of the CMM manufacturer's system responsibility, the following is only a basic fault diagnosis. For further diagnosis please contact the OEM.
Fault diagnosis:
Observation | Checklist |
|---|---|
Red LEDs not lit on head. | Check cable connections. Check fitting of PC card. Check secure fitting of head to male kinematic. |
Green LED will not illuminate. | Check 24 V power supply. |
No movement of head. | Check fitting and lock of arm probe. |
Possible overtravel signal when probe changing. | Check alignment of rack ports, |
Head powers up briefly then dies. | Check resistance of head power supply cables. Refer to PHS1 installation guide (Renishaw part number H-1000-4044). |