SPA3-2 servo power amplifier

• A drop-in replacement for the SPA3
• The SPA3-2 is compatible with the UCC controller range and the MCUlite-2, MCU5-2 and MCU W-2 joysticks
• This system can operate on the majority of CMM structures without the requirement for changing motors

Features

The SPA3-2 has the following improvements over the SPA3:

• The primary advantage of the SPA3-2 is the ample machine I/O: six inputs and seven outputs as well as six I/O ports which are configurable to be either inputs or outputs
• Adjustable power supply voltage to readheads and motor encoders
• Support for absolute BiSS readheads
• Support for up to four axes of position feedback for dual Y scale machines

Operating specification

• Three axis dc servo motor drive:
• • Independent axis voltage control of 12 V to 80 V
  • Independent axis current limits up to 9.5 A peak
  • Simulated linear power amplifier. Drive outputs are free from switching edges, eliminating noise from drive PWM, improving repeatability and reducing emissions
• Axis scale and motor encoder power supply: 5.25 V to 6.75 V, 0.5 A maximum (each)
• +24 V 1 A power supply for CMM solenoids, solid state switches, machine user specific hardware
• Digital input signals from air pressure, crash detection, all axis inner and outer travel limits and six user specific inputs
• Digital output signals to control machine air, axis brakes and seven user specific outputs
• Six configurable digital pins which can be independently configured to be either input or output

Front panel

Specification

■ Standard specification

- Not available

(1) Peak power of 600 W can be drawn for a maximum of 50 seconds

* SPA2-2 4-axis requires additional axis card

** Output voltage should approximately match input voltage