Home-CMM probes, software and retrofits-CMM support-CMM knowledgebase-3-axis systems-Scanning probe systems-SP80 / SP80H-SP80 and SP80H user's guide-Alignment of SCP80(V) to the CMM axes

Navigation

CMM support

  • CMM knowledgebase
  • 3-axis systems
  • Scanning probe systems
  • SP80 / SP80H
  • SP80 and SP80H user's guide
  • General information
  • Product compliance
  • Safety
  • System overview
  • Probe kit
  • Air supply
  • SH80 stylus holder
  • SH80K
  • Stylus change port
  • IU80 interpolator unit
  • Isolated optical metrology principle
  • Specification
  • System dimensions
  • System requirements
  • IU80 features and LEDs
  • SP80 LED control
  • Mounting / removing the SH80 / SH80K on the SP80 / SP80H body
  • Mounting styli on the SH80 and styli orientation
  • Aligning the KM80, KM6080 or SM80 for use with the SCP80(V)
  • Fitting the SCP80 / SCP80V to the MRS / MRS2 rack system
  • Alignment of SCP80(V) to the CMM axes
  • Establishing SCP80(V) port datums
  • Put down and pick up routines for SH80
  • Put down and pick up routine for SH80K with SP80
  • Put down and pick up routine for SH80K with SP80H
  • Modes of operation
  • SP80 and SP80H stylus selection
  • Maintenance

Navigation

CMM support

  • CMM knowledgebase
  • 3-axis systems
  • Scanning probe systems
  • SP80 / SP80H
  • SP80 and SP80H user's guide
  • General information
  • Product compliance
  • Safety
  • System overview
  • Probe kit
  • Air supply
  • SH80 stylus holder
  • SH80K
  • Stylus change port
  • IU80 interpolator unit
  • Isolated optical metrology principle
  • Specification
  • System dimensions
  • System requirements
  • IU80 features and LEDs
  • SP80 LED control
  • Mounting / removing the SH80 / SH80K on the SP80 / SP80H body
  • Mounting styli on the SH80 and styli orientation
  • Aligning the KM80, KM6080 or SM80 for use with the SCP80(V)
  • Fitting the SCP80 / SCP80V to the MRS / MRS2 rack system
  • Alignment of SCP80(V) to the CMM axes
  • Establishing SCP80(V) port datums
  • Put down and pick up routines for SH80
  • Put down and pick up routine for SH80K with SP80
  • Put down and pick up routine for SH80K with SP80H
  • Modes of operation
  • SP80 and SP80H stylus selection
  • Maintenance

Alignment of SCP80(V) to the CMM axes

Alignment of the SCP80 to the CMM axes

The alignment of the SCP80 to the CMM axes should be checked to be within the limits shown below.

Alignment of SCP80 to the CMM axes

Alignment of the SCP80V to the CMM axes

The alignment of the SCP80V to the CMM axes should be checked to be within the limits shown below.

Alignment of SCP80V to the CMM axes

CMM support

  • Knowledgebase
  • Manuals and installation guide downloads
  • Software downloads

CMM probes, software and retrofits

  • Hardware
  • Software
  • Retrofit
  • Support and downloads
  • 5-axis technology