Skip navigation

Installing external card

  • Remove the end panel of the PHC10-3 PLUS with a hex-key and slide out the blanking plate
  • Insert the PI 7-3 card, ensuring that the card is located in the correct grooves shown in the following illustration
  • Insert the reset actuator over the top of the reset button on the PI 7-3 card and then replace the end panel

Inserting PI 7-3 card into PHC10-3 PLUS

PI 200 card kit contents
Removing PHC10-3 end panel
Inserting PI 200 card in correct location
Inserting PI 200-3 card reset actuator
Ensuring PI 200 card is secured properly
Replacing PHC10-3 end panel