VM10 vision module
- The VM10 vision module can be used for inspecting features or holes that are typically larger than 1 mm, with a maximum field of view of 40 mm × 50 mm
- Typical applications for the VM10 module include the inspection of thin sheet metal parts like combustor casings for aerospace engines
NOTE: Dimensions in mm (in).
|Measurement||1 mm or larger diameter holes / features|
|Target applications||Aero engine combustor casings|
|Field of view||50 mm × 40 mm|
|Depth of field||5 mm (±2.5 mm)|
|Illumination||2 rings (8 + 16 LEDs)|
Stand-off is described as the distance required between the bottom of the vision module and the part feature to ensure optimum metrology performance.
Vision modules have different stand-off distances to allow the inspection of a variety of parts. The stand-off distance for the VM10 module is 80 mm.
VM10 field of view
The field of view for each vision module determines the size of feature than can be inspected using a single exposure when the RVP system is at the correct stand-off distance.
The VM10 field of view is 50 mm × 40 mm; any feature that requires inspection must be within these dimensions to be captured with a single exposure.
RVP module depth of field
The depth of field is the acceptable tolerance range for the focal point of the vision system that will still provide accurate metrology performance.
If the stand-off distance means that the focal point of the vision probe is outside of the 5 mm depth of field tolerance, then a reduction in metrology performance will be apparent.
REVO-2 RVP kits
RVP REVO-2 vision probe kit
VM10 vision module kit
VM11-2 vision module kit
VM12 vision module kit
VPCP vision probe change port kit
VMCP vision module change port kit
VA11 vision artefact kit
VA90 calibration adaptor
NOTE: Please visit the REVO-2 page for a full list of REVO-2 system and associated product part numbers.