List of compatible products

Hardware

GoProbe cycles are supported by the following touch-trigger probes¹.

Inspection probes

Tool setting probes

OMP40-2

OMP40M

RMP40

OMP60/OMP60M

OMP400

OMP600

RMP40/RMP40M

RMP400

RMP60/RMP60M

RMP600

Primo part setter

OTS

RTS

TS27R

TS34

Primo 3D tool setter

LTS

¹ _{Probe-on-probe calibration is only supported with PRIMO system hardware.}

GoProbe cycles are included in the following software packages:

GoProbe cycles are supported on the following controllers:

Brother, Fanuc/Meldas, Makino, Mazak machining centres, Okuma machining centres and Siemens.

Control type	Inspection Plus	Contact tool setting	GoProbe for Primo
Brother machining centres	A-4012-1028 Minimum version: 0E Recommended version²: 0H	A-4012-1007 Minimum version: 0K	Not applicable
Fanuc/Meldas machining centres	A-4012-0516 Minimum version: 0M Recommended version²: AE	A-4012-0584 Minimum version: AF	A-4012-1320
Makino machining centres	A-4012-1611 Minimum version: 0C	A-4012-1580 Minimum version: 0B	Not applicable
Mazak machining centres	A-4013-0112 Minimum version: 0T	A-4013-0133 Minimum version: 0Y	Not applicable
Mazak Integrex	A-4013-0106 Minimum version: 0H	Not applicable	Not applicable
Okuma machining centres	A-4016-1035 Minimum version: 0W	A-4016-1039 Minimum version: 0U	Not applicable
Siemens machining centres	A-4014-0356 Minimum version: 0E Recommended version²:0L	A-4014-0396 Minimum version: 0M	A-4014-0682

² _{The recommended version provides support for all cycles.}